Planted Terrarium Light

 The TerraSky Planted Terrarium Light is ideal for planted setups, paludariums and bioactive terrariums. The high intensity and enhanced penetration ensure that the light reaches all layers of the terrarium, resulting in sustained lush plant growth. Orchids, Bromeliads, Tillandsias (air plants), carnivorous plants, mosses and lichen all thrive under the TerraSky Planted Terrarium Light’s strong Photosynthetic Active Radiation (PAR). The 120-degree light dispersion provides a nice even illumination and covers the complete area to avoid dark spots. The waterproof housing of the TerraSky High output LEDs is rated IP54 for use in humid environments. The extendable mounting brackets allow easy installation on all Small & Medium Natural Terrariums, and other terrariums between 38 and 60 cm wide.

REMOTE CONTROL

1. Simply push any of the pre-programmed color spectrum buttons
to switch between the 6 different base color settings. These
pre-programmed color spectrums are the most commonly used
color spectrums for terrariums. They also form the base from
which you can start custom blending your own preferred color
spectrum (see step 2 and 3).

2. To fine-tune these base color settings, simply press any of the
+ or – color buttons (red-green-blue-white) to adjust the RGBW
LED’s output. Each individual RGBW color can be increased or
decreased in output strength or even shut off completely by
using the + or – color buttons to create the perfect light color for
your application.

3. If you are satisfied with the result of your customised color
setting: press and hold any of the 4 customisable preset buttons
(P1-P2-P3-P4) for 4 seconds to store your customised color
setting. The TerraSky will flash once, once the setting is stored.
Repeat as desired until all 4 customisable preset buttons have
been programmed.

4. To simulate Moon Lighting, there are 3 different Moon Light
buttons to choose from, depending on the Moon Cycle you would
like to use at night.

5. To simulate Cloud Cover during daytime, there are 4 different
Cloud Cover strength buttons to choose from, depending on
whether you would like lightly clouded sky or up to dark stormy
clouds.

6. To simulate Storm Effects, there are 3 different Storm Effect
strengths to choose from. Going from lightly clouded sky with
the occasional lightning, up to dark stormy clouds with lots of
lightning.

7. With the Play/Pause button, you can play or pause any dynamic
light effect.

8. The Sunrise/Sunset button allows you to simulate a gentle
Sunrise or Sunset lighting effect. Without pushing the ON button,
simply push the Sunrise/Sunset button in the morning to start
the Sunrise. Push the Sunrise/Sunset once again in the evening
to start the Sunset.

9. The Color Spectral Cycle button will slowly cycle through every
color spectrum.